Adjustable spring preload
Adjustable rebound damping
Adjustable compression damping
Open cartridge technology
Greater stability
Improved damping behavior
Improved and calmer ride
Greater comfort
Improved handling

Scope of delivery

Cartridge
Sticker

Front fork springs need to be ordered separately.

CNC milled from high-strength aluminum
Elegant anodised surface
Modern, subtle, and timeless design
Visual highlight
Ball joint, for flexible adjustment of the rear mirror
Adjustable handle

CNC milled from high-strength aluminum
Elegant anodised surface

Perfectly integrated into the motorcycle
Reliable protection of valuable motorcycle components
Prevents abrasion of the frame by dirt, falls or the driver's boots
Protects the frame without changing the slim lines of your motorcycle
Mounting directly on the frame

Front brake disc 270mm

FloatingOuter ring made of stainless high-performance brake steel
Inner ring anodised
Minimal wear on brake pads
With Flame design for added braking performance
Up to 20% weight saving compared to stock components;
Incl. the required CNC machined, black anodized brake caliper support for Brembo brake systems

Uncompromising race look
Extremely light
Open design

Attached directly at the levers with a special mounting.
Only mountable with Brembo brake system

Optimal protection against penetration of mud, sand and water into the wheel bearing of your wheel
Reduces wear on sealing rings and wheel bearings for longer service life
Incl. special low friction shaft sealing rings

Protects the brake disc in the event of a fall
High stiffness and strength
Protects the rear brake disc from stones and other solid obstacles
CNC milled from high-strength aluminum
Lighter than series components
Improved braking performance

Right grip permanently glued to the throttle grip
Left grip with aluminum clamping ring for fixing on the handlebar
Inconvenient gluing and securing with wire no longer necessary
The different guide plates allow a variation of the throttle valve opening.

Prevents the chain from hitting the rear tyre
Perfect chain guide, no branches drawn in between chain and engine housing

High-end steering damper
Maximum control on fast tracks
Gain in stability at the front wheel
Fully adjustable
Well thought-out mounting of the damper enables individual handlebar adjustment
Reduced weight
Sensitive response behavior
High speed DCC
Developed according to the requirements of our factory drivers
Optimum 25 click setting range.
Proven success with the KTM Works Rally Team.
For use on Enduro MY21 and later (EU Version), the Factory fuel tank cap vent is required

Required Article:
STEERING DAMPER COUNTER BEARING (77212905444)
STEERING DAMPER BRACKET (58512050144)

Contains all parts for dismantling the side stand
Simulates a folded up side stand
Plug & Play mounting

Protects display from unwanted scratches and marks
Made of high-grade, anti-scratch material
Made from high quality tempered glass

Most effective protection for frame and engine
Easy to mount
Protects the linkage from damage
Extremely light
Extremely durable
Highest quality workmanship
Endurance-tested for the toughest off-road applications
Custom design

Recommended article:
FOAM RUBBER (59003990250)

mproves clutch performance and durability
Hinson-typical surface treatment for significantly improved robustness compared to the standard part
Very clean running of the clutch, which leads to reduced heat development when the clutch is pulled
Can be installed in the standard clutch or in combination with other Hinson clutch components
CNC milled from high-strength aluminum
Improves heat dissipation

Endurance-tested for the toughest off-road applications
Easy to mount
Made from high-strength and robust C-SMC material (Carbon Sheet Molding Compound)
Extremely light
Extremely durable
Highest quality workmanship
Most effective protection for frame and engine
Decoupled from the frame by rubber pads
Mounting directly on the frame
Custom design
Thickness: 3 mm


FOAM RUBBER (59003990250)